Website design By BotEap.comIf you’ve decided to renovate your kitchen, then you’re probably sick of looking for new hardware, what finish to put on the cabinet front, and so on. One thing to know, however, is what size drill bit to use for cabinet knobs. The last thing you want to do with those new cabinet doors is damage them. There are just a few tricks you need to get the job done right without risking the cabinet’s finish.
Website design By BotEap.comFirst, a brief introduction to drawer pull handles. You basically have two types, knob and handle. They can be attached in different methods.
Website design By BotEap.comMany handles will have two small screw holes built into the outer flange. These are the easiest to install.
Website design By BotEap.comFor thicker flush mount pulls and individual knobs, they are bolted through the back of the cabinet and then threaded into the hardware. You will have to be much more careful when drilling the holes for this.
Website design By BotEap.comThe first step of any job is the prep work. You will need a couple of different sized drill bits, so choosing a drill rate is a good idea. You won’t need a full index, you can accomplish everything you need with a selection of bits ranging from ¼ to ½ inch.
Website design By BotEap.comMake sure the tips are sharp. The last thing you want is to risk the bit walking across the surface of the cabinet or splintering the wood.
Website design By BotEap.comFor the screw type handle, the installation is really simple. Just mark where the screws go. Tap in a pilot hole about a third of the way through the face of the cabinet and drive the screws in.
Website design By BotEap.comBolt on handles will take a little more time and prep work.
Website design By BotEap.comA single bolt knob is the next step up in complexity. For this you will need to measure from the edge of the knob to the center of the bolt hole. This will be your drilling compensation.
Website design By BotEap.comPlace a piece of masking tape over the face of the cabinet where the knob will be installed. Now trace around the perimeter of the knob. Take your offset measurement to mark where the center of the bolt hole is.
Website design By BotEap.comUse the ¼-inch drill bit to close up a pilot hole. Make sure you drill from front to back, I know it’s counterintuitive but this way if you have any splinters it will be on the inside of the cabinet.
Website design By BotEap.comNow simply increase the size of the bits until you get to a size large enough to drive the deadbolt through the door.
Website design By BotEap.comRemove the tape, put the bolt in place and tighten the knob.
Website design By BotEap.comThe most complex door handle will have two bolts. The basic principle is the same.
Website design By BotEap.comapply tape
measure displacement
Trace the handle.
Mark the tape.
Website design By BotEap.comDrill the pilot hole and then size up to the size of the bolt.
Website design By BotEap.comThe only difference in connection is that you will be tightening the bolt from the back of the cabinet.
Website design By BotEap.comSo what size drill bit to use for cabinet knobs is a bit of a misnomer. You’ll need quite a few different sizes to achieve a sleek, professional look.
