Flying Monkey Delta 8 Disposable Propane Engine
Is it possible to clean a Flying Monkey Delta 8 Disposable in a similar fashion to how you clean a disposable? It certainly is, and I will show you how in a few minutes. The first thing you want to do when cleaning your machine is to make sure all of the hoses and fittings are completely dry. If they aren’t then this can cause a lot of problems when you are washing the next disposable away.
To clean the hose, first pull out the hose and attach the hose clamp to the fitting at the bottom of the machine. Now you want to push the clamp down and then turn it around and push the hose towards the drain. If there is any debris in the hose or clamps, then you will have to get them out now.
Flying Monkey Delta 8 Disposable
Once the hose is clean and dry, pull the hose and nozzle out of the tank. You will see the two rings on the bell of the machine, which are the notches that allow you to take the filter off and put it back in. You will also see the rubber o-ring, which is the rubber O-ring that connects the air cylinder to the piston. You will also notice that there are black veins on the rubber o-ring. These are the bits that you will have to remove to allow the cleaning to take place.
Website design By BotEap.com
How to Perform the Changing of the Flying Monkey Delta 8 Disposable Propane Engine
The next step is to remove the o-ring, while holding the clamps together. Start by turning the valve clockwise, while pulling the o-ring towards the wall. Once you reach the base of the filter, then pull it completely out. You will notice that there are little pieces of black plastic here and there, which are the pieces of the filter. Again, these pieces must be removed before you are ready to install the new one.
Next, the black veins must be unscrewed and then replaced with the new rubber o-ring. This process should be done in a slow and steady manner, so as not to damage any of the pipes. When the rubber o-ring is replaced, reattach the pipe clamps and then attach the hose to the flying disc.
Finally, attach the remote control to your remote control. The spinning action will start the air pump, which fills the air in the pipe. It will be advisable to hold the flying disc while spinning, so as to ensure that it is spinning properly. In order to make sure that everything is working correctly, you can add a little bit of oil to the rubber o-ring. With a little bit of oil, the rubber o-ring will last a long time, and the entire operation of the RC flying vehicle will be a lot more enjoyable.